The short version
Key points
- The TP-Link Deco X50 is a three-unit Wi-Fi 6 mesh system with three gigabit ports on each unit.
- The main Deco must be configured first through the Deco app before adding the other units.
- The additional units can be powered on and automatically added to the existing mesh network.
- The units were placed in the living room, hallway and theatre area.
- The video describes the system as supporting coverage of up to 600 square metres and speeds of up to 3Gbps, according to the setup information shown.
What is included with the Deco X50 system
The video covers the TP-Link Deco X50, also referred to as the AX3000. It is presented as a mid-range Wi-Fi 6 mesh system aimed at medium to large homes. The three-pack includes three Deco units and one Ethernet cable.
Each unit has three gigabit Ethernet ports and a power connection. The compact design allows the units to be positioned around the home without taking up much space, although the video notes that the patterned top may collect dust.
Preparing the network hardware
Before installing the units around the home, TechManPat unboxes and prepares the system at a desk. A five-port gigabit desktop switch is also used as a convenient way to split a network connection when working with several wired devices.
The existing home network is an older TP-Link mesh system. The plan is to replace it with the Deco X50 units, while keeping the older equipment available for devices or testing where required. The Wi-Fi network name is changed during setup, with the possibility of using the previous name and password to reduce the need to reconnect existing devices.
Setting up the first Deco unit
The first Deco is connected to the internet connection and becomes the main unit for the mesh. Setup is completed in the TP-Link Deco app by selecting the option to add a new Deco system and scanning the unit. A pulsing blue light indicates that the device is ready to be configured.
The app is used to name the network and identify the location of the main unit. TechManPat places this unit in the living room, where the previous mesh equipment was located. The main Deco needs to be configured before the other units are added.
Adding and positioning the remaining units
Once the first Deco is active, the other two units are added through the app. They are powered on and recognised as part of the existing network, making the process considerably simpler than configuring each device separately.
The three units are assigned to the living room, hallway and theatre area. The theatre unit is positioned behind a television. The video acknowledges that TP-Link's instructions advise against placing a Deco near large electronic devices or between books and other obstructions, but TechManPat considers the position acceptable for this installation.
Coverage and speed testing
The setup information indicates coverage of up to 600 square metres and speeds of up to 3Gbps. These figures are presented as the system's stated capabilities rather than as results from an independent test.
After installation, a Wi-Fi 6-enabled computer is used for testing. A 2.5Gbps Ethernet adapter is connected to the laptop, and a local speed-test server is configured to measure the connection through the mesh. The video shows the test operating and reaching the 500 to 600 range on screen, but it does not provide a formal final result or a detailed comparison with the previous system.
TechManPat’s conclusion
I think the Deco X50 is a practical option for extending Wi-Fi across a medium to large home without moving to a much more expensive high-end router. The three-unit setup was straightforward through the Deco app, and I was happy to replace my older home mesh system with it. My main advice is to run only one primary network and position the units as openly as possible for the best chance of consistent coverage.
This knowledge-centre summary is based on the linked TechManPat video and reflects the information available when it was published. Check current pricing, availability and policies before acting.
